Table of Contents
Advertisement
10–Internal settings
Auto Ready
Turn the auto ready function
If auto ready is
, when playback of a take completes the
ON
unit automatically stops at the beginning of the next take.
This setting affects all modes except timeline mode.
Inc. Play
Turn the incremental play function
When incremental play is
ON
playback to move to the beginning of the next take and
continue playing, or press the STOP (RETAKE) key during
playback to move to the beginning of the next take and
pause playback.
This setting affects all modes except timeline mode.
PLAY Inhibit Time
This sets a time interval during which playback of the
same take (entry) cannot be restarted.
The following keys and commands are disabled (excluding
flash start keys/commands for other takes/entries) for the
duration of this setting. The following keys and commands
are disabled (excluding flash start keys/commands for
other takes/entries) for the duration of this setting. The
PLAY key on the front panel of the unit, the PLAY key,
flash start keys and fader start function of the TASCAM
RC-HS20PD remote control (sold separately), and play and
flash start commands from external controllers (RS-232C/
RS-422/ Parallel/ Keyboard).
Setting range:
msec (100 msec intervals),
0–1000
(during playback the affected keys are disabled for this
amount of time)
Default value:
0 msec
NOTE
When the
PLAY Inhibit Time
incremental play function is automatically fixed to OFF
and cannot be switched to ON.
92
TASCAM HS-2
or
(default).
ON
OFF
or
(default).
ON
OFF
, press the PLAY key during
Inf
item is set to
, the
Inf
Sync and time code settings (SYNC T/C)
Make various settings related to audio synchronization
and time code on this page.
This screen has five pages:
. Touch the tabs at the bottom of the screen to open
I/O
the corresponding page.
CLOCK page
View various clock status information and select the clock
used for synchronization.
STATUS
Project:
Displays the sampling frequency of the project.
CLOCK:
Displays the clock synchronization status.
WORD/VIDEO:
Displays
,
WORD
VIDEO
is detected at the input.
D-IN:
Displays the digital input signal status as shown in
the following table:
Digital input signal status
Locked
When sampling rate conversion
is ON
Unlocked
No signal
No audio signal present
Other Cbit information differs
from the actual operation mode
MASTER
Use the buttons to select the master clock to use.
INT button (default):
Use this unit's internal clock.
WORD button:
Synchronize with the word clock input through the
WORD/VIDEO IN connector.
VIDEO button:
Synchronize with the video clock input through the
WORD/VIDEO IN connector.
,
,
,
and
CLOCK
SYNC
T/C
SETUP
or
if such a signal
TriLevel
Display
Locked (xx.xxx kHz)
Locked
(xx.xxx
kHz
FsCnv)
Unlocked (xx.xxx kHz)
Unlocked (no signal)
Not Audio
Unmatched Cbit
Advertisement
Table of Contents
