Editing The Name Of The First Session; Loading Projects; Rebuilding Projects - Tascam HS-2 Owner's Manual

Editing the name of the first session

Touch the
Session Name
screen to open the
PROJECT
shown below.
Follow the same procedures as in "Editing the project
name" on page 38 to change the name.
NOTE
Session names cannot be changed later.

Loading projects

1 Press the PROJECT key on the front panel to open
the screen.
PROJECT
2 Select the project that you want to load.
3 Touch the button on the
MENU
open a pull-up menu.
4 Touch the button in the pull-up menu.
LOAD
NOTE
When multiple projects are selected, the
available.
5 Touch the button or press the DATA dial when
OK
the confirmation pop-up message appears.
After loading completes the Home Screen opens.
button on the
CREATE
screen, as
1st SESSION
screen to
PROJECT
item is not
LOAD

Rebuilding projects

Rebuilding (file rescan) should be performed whenever
there is an inconsistency between the unit's file lists and
the actual directory contents that may occur, for example,
when an audio file has been deleted via FTP.
1 Press the PROJECT key on the front panel to open
the screen.
PROJECT
2 Select the project that you want to rebuild.
You can touch the
MULTI SELECT
screen to allow the selection of multiple
PROJECT
projects.
3 Touch the button on the
MENU
open a pull-up menu.
One project selected
Multiple projects selected
4 Touch the button in the pull-up menu.
REBUILD
5 Touch the button or press the DATA dial when a
OK
confirmation pop-up message appears.
During rebuilding, a progress status pop-up appears.
When rebuilding completes, the pop-up disappears.
NOTE
If you select REBUILD when no project has been selected
in the PROJECT screen, the entire content of the selected
card is rebuilt.
5–Projects
button on the
screen to
PROJECT
39
TASCAM HS-2