Adhesive Labels - NEC 870 - SuperScript B/W Laser Printer Online User's Manual

Appendix A: Selecting Print Media
• #6 3/4 envelope 3.625 in. x 6.5 in .(92.08 mm x
165.1 mm )
• #8 5/8 envelope 3.625 in. x 8.625 in. (92.08 mm
x 219.08 mm)
• #9 envelope 3.875 in. x 8.875 in. (98.43 mm x
225.43 mm)
• #11 envelope 4.5 in. x 10.375 in. (114.30 mm x
263.53 mm)
• #12 envelope 4.75 in. x 10.375 in. (120.65 mm x
263.53 mm)
• #14 envelope 5 in. x 11.5 in. (127 mm x 292.10
mm)
• DL envelope 4.33 in. x 8.66 in. (110 x 220 mm)
• C5 envelope 6.38 in. x 9.02 in. (162 x 229 mm)
• B5 envelope 6.93 in. x 9.84 in. (176 x 250 mm)
Note: NEC neither warrants nor
guarantees the use of any particular
envelope and the user assumes all
responsibility as to the quality and
performance of the envelopes selected.
The leading edge of an envelope that feeds into
the printer must be straight. The fold must be
firmly creased and be no thicker than two paper
thicknesses. As a rule, the larger the envelope is,
the more difficult it is to feed properly.
You should load envelopes with the flap edge to
the left. The address side must face up and the
flap side must face down.
130

Adhesive Labels

Adhesive labels consist of a top (print surface)
sheet, an adhesive layer, and a liner (peel-away
backing). The top sheet is usually xerographic
paper and must meet the general specifications for
that kind of paper. The liner must be coated for
easy release of the top sheet and adhesive layer
sheets, particularly after being subjected to print
head heat. Do not use label stock with the backing
sheets exposed between the individual labels
OK
Note: Label properties can be changed
by the manufacturers. NEC has no control
over such changes. Thus NEC neither
warrants nor guarantees the use of any
particular label and the user assumes all
responsibility as to the quality and
performance of labels selected.
AVOID