NEC 870 - SuperScript B/W Laser Printer Online User's Manual page 49

setup dialog boxes. Therefore, you cannot
use these programs to successfully
perform Booklet Printing.
8. Print your document when ready. The
SuperScript 870 Windows Printer Driver will
print the first side of the booklet pages, with
an instruction sheet. You may print to either
the Main output tray or the rear Face-up
output tray.
9. After the first side has printed, the printer will
pause and wait for you to reinsert all the
pages back into the Manual feed tray or the
Multi-purpose tray according to directions on
the instruction sheet. Press the Operator panel
button. When finished printing, you can fold
the pages to complete the booklet.
Paper Source Tab
The settings in the Paper Source tab allow you to
control the paper size and paper source that will
be used for your print jobs. The Paper Source tab
includes these settings:
• Paper Source Selection
• Paper size
• Paper type
Chapter 3: Installing the Software
Note: If you have purchased additional
accessories for your printer, like the 500-
Sheet cassette, you must select this
option from the Accessories tab in order
for the option to be selectable from the
driver. (See the Accessories tab
explanation later in this Chapter.)
The Summary area at the bottom of the dialog
box reports the current settings.
Each of the settings of the Paper Source tab is
described below.
Paper Source Selection
This setting enables you to use a different paper
source for the first page of a print job than for the
remaining pages. For example, you can use this
49