Ignition Coil Inspection - DAELIM DAYSTAR Service Manual

Ignition System

Ignition Coil Inspection

Remove the seat
Remove the Fuel Tank
Disconnect the primary circuit.
Measure the ignition coil primary coil
resistance between the ignition coil terminal
and ground.
Standard: (Resistance) 0.2 0.02
(Voltage) Over 100V
Disconnect the spark plug caps from the spark
plugs.
Measure the secondary coil resistance between
the ignition coil spark plug caps and ground.
Standard: 5 1.25
NOTE
• Don't measure the secondary coil voltage of
ignition coil.
If the measurement is out of specification,
check the secondary coil resistance without the
plug caps from the high tension code.
Replacement
Disconnect the tension code from the plug and
clamp. Remove the primary circuit from the
ignition coil. Loosen the two bolts and
remove the ignition coil.
Installation is the reverse order of removal.
17-4
K
Ignition Coil Ignition Coil Ignition Coil Ignition Coil
Ignition Coil Ignition Coil Ignition Coil Ignition Coil
Ignition Coil Ignition Coil
Ignition Coil Ignition Coil Ignition Coil
High Tension Code High Tension Code
High Tension Code High Tension Code
High Tension Code High Tension Code High Tension Code High Tension Code
High Tension Code High Tension Code High Tension Code High Tension Code
High Tension Code
Ignition Coil Ignition Coil Ignition Coil Ignition Coil
Ignition Coil Ignition Coil
Ignition Coil Ignition Coil Ignition Coil Ignition Coil
Ignition Coil Ignition Coil Ignition Coil
High Tension Code High Tension Code
High Tension Code High Tension Code
High Tension Code High Tension Code High Tension Code High Tension Code
High Tension Code High Tension Code High Tension Code High Tension Code
High Tension Code