DAELIM DAYSTAR Service Manual page 118

● Install the kick starter into the right crankcase,
hanger the end of the kick starter spring on the
case hole.
● Turn the ratchet and ratchet guide plate to the
right and place them as shown.
● Be careful to prevent 12mm kick starter thrust
washer from falling. Install the right crankcase
into the left crankcase while pressing the kick
starter to prevent the ratchet and guide plate
from falling.
● After installation of the kick starter pedal
temporarily, turn the kick starter to the right
slowly to align the end of the spindle with the
left crankcase assembling hole thoroughly.
NOTE
• Make sure that there is no gap between the
mating surfaces of the right and left crankcase.
Crank Case / Transmission / Crankshaft / Kick Starter
Guide Plate Guide Plate
Guide Plate Guide Plate
Guide Plate Guide Plate Guide Plate Guide Plate
Guide Plate Guide Plate
Guide Plate Guide Plate Guide Plate
12mm Thrust Washer 12mm Thrust Washer
12mm Thrust Washer 12mm Thrust Washer
12mm Thrust Washer 12mm Thrust Washer 12mm Thrust Washer 12mm Thrust Washer
12mm Thrust Washer 12mm Thrust Washer
12mm Thrust Washer 12mm Thrust Washer 12mm Thrust Washer
Kick Starter Pedal Kick Starter Pedal Kick Starter Pedal Kick Starter Pedal
Kick Starter Pedal Kick Starter Pedal
Kick Starter Pedal Kick Starter Pedal Kick Starter Pedal Kick Starter Pedal
Kick Starter Pedal Kick Starter Pedal Kick Starter Pedal
Retchet Retchet
Retchet Retchet
Retchet Retchet Retchet Retchet
Retchet Retchet
Retchet Retchet Retchet
10-13