Carburetor Idle Speed; Drive Chain - DAELIM DAYSTAR Service Manual

Maintenance

Carburetor Idle Speed

NOTE
•Inspect all other engine adjustments are within
specifications and adjust idle speed.
•The engine must be warm for accurate
adjustment. Support the motorcycle on a level
surface and shift the transmission into neutral.
Check the idle speed and adjust by truning the
throttle stop screw if necessary.

Drive Chain

NOTE
•Stop the engine to inspect the drive chain,
otherwise fingers can be caught in the drive
chain while the drive chain is operating.
Chain Free Play Adjustment
● Stop the engine and shaft the gear into neutral,
support the motorcycle on a level surfase.
● Remove the chain tensioner.
● Move the position of chain tensioner roller up
and down with hands to check if the chain free
play is within recommended range.
Free Play: 50~60mm
● If necessary, adjust the drive chain free play.
● Adjust by loosening the axle nut and lock nuts
in the right/left chain adjusters and turning the
adjusting nut.
NOTE
•Adjust the chain adjuster reading scale into the
same place in the right and left sides.
Tighten the axle nut
Torque: 88kgf-m(88N.m)
Removal/Inspection
● Inspect the drive chain for contamination.
3-8
Throttle Stop Screw Throttle Stop Screw Throttle Stop Screw Throttle Stop Screw
Throttle Stop Screw Throttle Stop Screw Throttle Stop Screw Throttle Stop Screw
Throttle Stop Screw Throttle Stop Screw
Throttle Stop Screw Throttle Stop Screw Throttle Stop Screw
50~60mm
Retainer Clip Retainer Clip Retainer Clip Retainer Clip
Retainer Clip Retainer Clip Retainer Clip Retainer Clip
Retainer Clip Retainer Clip
Retainer Clip Retainer Clip Retainer Clip