Table of Contents
Advertisement
c. Select Console Redirection Settings; then, make sure that the values are set as follows:
v COM Port 1: Enable
v Remote Console: Enable
v Serial Port Sharing: Enable
v Serial Port Access Mode: Dedicated COM1 Settings
v Baud Rate: 115200
v Data Bits: 8
v Parity: None Stop
v Bits: 1
v Thermal Emulation: ANSI
v Active After Boot: Enable
v Flow Control: Hardware
d. Press Esc twice to exit the Devices and I/O Ports section of the Configuration/Setup Utility
program.
e. Select Save Settings; then, press Enter.
f. Press Enter to confirm.
g. Select Exit Setup; then, press Enter.
h. Make sure that Yes, exit the Setup Utility is selected; then, press Enter.
Chapter 7. Configuring the server
111
Advertisement
Table of Contents
