Replacing A Microprocessor And Heat Sink; Removing The Microprocessor - Lenovo 653417U Installation And User Manual

Machine types: 6531, 6532, 6533, and 6534
Table of Contents

Advertisement

The following illustration shows installing a hot-swap 2.5-inch drive cage.
To install a drive cage, complete the following steps:
1. Make sure that the backplane or back plate is removed from the drive cage. (See "Removing the
backplane or back plate (3.5-inch drives)" on page 72 or "Removing the SAS backplane (2.5-inch
drives)" on page 74 for instructions, as applicable.)
2. Line up the drive cage with the drive bays on the front of the server.
3. Push the drive cage into the server until it stops.
4. Align the holes in the top of the drive cage with the holes in the top of the chassis; then, insert the
screws that secure the drive cage to the chassis.
5. Install the backplane or back plate. (See "Installing the backplane or back plate (3.5-inch drives)" on
page 72 or "Installing the SAS backplane (2.5-inch drives)" on page 75 for instructions, as applicable.)
6. Install the hard disk drives.
7. Go to "Completing the installation" on page 47.

Replacing a microprocessor and heat sink

The following notes describe the type of microprocessor that the server supports and other information
that you must consider when you install a microprocessor:
v The server supports one Intel land grid array (LGA) 1156 dual-core or quad-core microprocessor. The
type, speed, and L3 cache of the microprocessor depends on the server model.
v Read the documentation that comes with the microprocessor to determine whether you have to update
the server firmware. To download the most current level of server firmware, go to go to
http://www.lenovo.com/support.
v The microprocessor uses an integrated voltage regulator on the system board.

Removing the microprocessor

To remove the microprocessor, complete the following steps.
1. Read the safety information in "Safety" on page vii and "Installation guidelines" on page 25.
2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3. Remove the server from the rack; then, remove the cover (see "Removing and installing the cover"
on page 29).
58
ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Installation and User Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkserver rs210

Table of Contents