Table of Contents
Advertisement
1
Expansion-slot cover
2
Expansion slot 2
3
Expansion slot 1
4
Expansion-slot cover
10. If you are instructed to return the PCI card, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Installing a PCI card
To install a PCI card, see "Installing an optional PCI card" on page 42.
Replacing a USB embedded hypervisor flash device
To replace a hypervisor flash device, complete the following procedures:
Removing a USB embedded hypervisor flash device
To remove a hypervisor flash device, complete the following steps:
1. Read the safety information in "Safety" on page vii and "Installation guidelines" on page 25.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing and installing the cover" on page 29).
4. Remove the riser-card assembly (see "Removing the riser-card assembly" on page 75).
5. Unlock the retention latch on the USB connector by squeezing the two retention clips toward each
other (see "System-board internal connectors" on page 16.
52
ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Installation and User Guide
5
PCI card
6
Guide channels
7
Riser-card assembly
8
PCI card
Advertisement
Table of Contents
