Using Lsi Configuration Utility Program - Lenovo 653417U Installation And User Manual

Table 15. RAID configuration utilities (continued)
RAID configuration utility Description
MegaRAID BIOS
Configuration Utility
(WebBIOS)
LSI Configuration Utility

Using LSI Configuration Utility program

Use the LSI Configuration Utility program to configure and manage redundant array of independent
disks (RAID) arrays. Be sure to use this program as described in this document.
v Use the LSI Configuration Utility program to perform the following tasks:
– Perform a low-level format on a hard disk drive
– Create an array of hard disk drives with or without a hot-spare drive
– Set protocol parameters on hard disk drives
The integrated SAS/SATA controller with RAID capabilities supports RAID arrays. You can use the LSI
Configuration Utility program to configure RAID 1 (IM), RAID 1E (IME), and RAID 0 (IS) for a single
pair of attached devices. If you install a different type of RAID controller, follow the instructions in the
documentation that comes with the adapter to view or change settings for attached devices.
When you are using the LSI Configuration Utility program to configure and manage arrays, consider the
following information:
v The integrated SAS/SATA controller with RAID capabilities supports the following features:
– Integrated Mirroring (IM) with hot-spare support (also known as RAID 1)
96
ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Installation and User Guide
For:
v A IBM ServeRAID-BR10il
v2 SAS/SATA Controller
v An optional IBM
ServeRAID-MR10i
SAS/SATA Controller
v An optional IBM
ServeRAID-M1015
SAS/SATA controller
v An optional IBM
ServeRAID-MR10is VAULT
SAS/SATA controller
v An optional IBM
ServeRAID-MR 5015
SAS/SATA controller
For:
v A IBM ServeRAID-BR10il
v2 SAS/SATA Controller
v An optional IBM
ServeRAID-MR10i
SAS/SATA Controller
v An optional IBM
ServeRAID-M1015
SAS/SATA controller
v An optional IBM
ServeRAID-MR10is VAULT
SAS/SATA controller
v An optional IBM
ServeRAID-MR 5015
SAS/SATA controller
Location
In system firmware. To
access:
v Use UEFI Setup Utility.
v Press Ctrl + H at the
WebBIOS prompt
during startup.
In system firmware. To
access:
v Use UEFI Setup Utility.
v Press Ctrl + C at the LSI
prompt during startup.
Where to find more
information
"Using the WebBIOS
utility" on page 98
"Using LSI Configuration
Utility program"