Table of Contents
Advertisement
Using the Boot Manager program
The Boot Manager program is a built-in, menu-driven configuration utility program that you can use to
temporarily redefine the first startup device without changing settings in the Setup Utility.
To use the Boot Manager program, do the following:
1. Turn off the server.
2. Restart the server.
3. When the prompt <F12> Select Boot Device is displayed, press F12. If a bootable USB mass storage
device is installed, a submenu item (USB Key/Disk) is displayed.
4. Use the Up arrow and Down arrow keys to select an item from the Boot Selection Menu and press
Enter. The server attempts to boot from the selected device.
The next time the server starts, it returns to the startup sequence that is set in the Setup Utility.
Configuring RAID controllers
The following table lists the various utilities available to configure RAID controllers before an operating
system is installed.
Table 15. RAID configuration utilities
RAID configuration utility Description
EasyStartup RAID
configuration utility
v For use with all supported
RAID controllers
v Automatically detects
hardware and lists all
supported RAID
configurations
v Configures one or more
disk arrays per controller
depending on the number
of drives attached to the
controller and the RAID
level selected
v Supports hot-spare drives
v Creates a RAID response
file that can be used to
configure RAID controllers
on similarly configured
Lenovo servers.
Location
EasyStartup DVD
Chapter 7. Configuring the server
Where to find more
information
"Using the EasyStartup
DVD" on page 100
95
Advertisement
Table of Contents
