Lenovo 653417U Installation And User Manual page 132

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See the Hardware Maintenance Manual to determine which components are customer replaceable units (CRUs)
and which components are field replaceable units (FRUs).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
v Go to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information, hints,
tips, or new device drivers.
Error code Description
0050001 DIMM disabled.
0051003 Uncorrectable DIMM error
0051006 DIMM mismatch detected
0051009 No memory detected.
005100A No usable memory detected.
0058001 PFA threshold exceeded
116
ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Installation and User Guide
Action
1. If the server fails the POST memory test, reseat
the DIMMs.
2. Remove and replace any DIMM for which the
associated error LED is lit (see "Replacing or
installing a memory module (DIMM)" on page
32).
3. Run the Setup utility to enable all the DIMMs.
4. Run the DSA Preboot memory test (see
"Diagnostic tools" on page 113).
1. If the server failed the POST memory test, reseat
the DIMMs.
2. Remove and replace any DIMM for which the
associated error LED is lit (see "Replacing or
installing a memory module (DIMM)" on page
32).
3. Run the Setup utility to enable all the DIMMs.
4. Run the DSA Preboot memory test (see
"Diagnostic tools" on page 113).
Make sure that the DIMMs match and are installed in
the correct sequence (see "Installing a memory
module" on page 36).
1. Make sure that the server contains DIMMs.
2. Reseat the DIMMs.
3. Install DIMMs in the correct sequence (see
"Installing a memory module" on page 36).
1. Make sure that the server contains DIMMs.
2. Reseat the DIMMs.
3. Install DIMMs in the correct sequence (see
"Installing a memory module" on page 36).
4. Clear CMOS memory to re-enable all the memory
connectors (see Table 4 on page 20).
1. Update the server firmware to the latest level (see
"Updating the firmware" on page 103).
2. Reseat the DIMMs and run the memory test (see
"Diagnostic tools" on page 113).
3. Replace the failing DIMM, which is indicated by
a lit LED on the system board.