Preparing To Use Asdm; Gathering Configuration Information For Initial Setup - Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Manual

Using the Adaptive Security Device Manager for Configuration

Preparing to Use ASDM

Step 1
Step 2
Step 3

Gathering Configuration Information for Initial Setup

Cisco ASA 5500 Series Getting Started Guide
7-4
Before you can use ASDM, perform the following steps:
If you have not already done so, connect the MGMT interface to a switch or hub
by using the Ethernet cable. To this same switch, connect a PC for configuring the
adaptive security appliance.
Configure your PC to use DHCP (to receive an IP address automatically from the
adaptive security appliance), which enables the PC to communicate with the
adaptive security appliance and the Internet as well as to run ASDM for
configuration and management tasks.
Alternatively, you can assign a static IP address to your PC by selecting an address
in the 192.168.1.0 subnet. (Valid addresses are 192.168.1.2 through
192.168.1.254, with a mask of 255.255.255.0 and default route of 192.168.1.1.)
When you connect other devices to any of the inside ports, make sure that they do
not have the same IP address.
The MGMT interface of the adaptive security appliance is assigned
Note
192.168.1.1 by default, so this address is unavailable.
Check the LINK LED on the MGMT interface.
When a connection is established, the LINK LED interface on the adaptive
security appliance and the corresponding LINK LED on the switch or hub turn
solid green.
Gather the following information to be used with the ASDM Startup Wizard:
A unique hostname to identify the adaptive security appliance on your
•
network.
The domain name.
•
Chapter 7 Configuring the Adaptive Security Appliance
78-19186-01