Cabling 4Ge Ssm Interfaces - Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Manual

Cabling 4GE SSM Interfaces

Cabling 4GE SSM Interfaces
Step 1
Step 2
Cisco ASA 5500 Series Getting Started Guide
15-2
To cable 4GE SSM interfaces, perform the following steps for each port you want
to connect to a network device:
To connect an RJ-45 (Ethernet) interface to a network device, perform the
following steps for each interface:
a. Locate a yellow Ethernet cable from the accessory kit.
Connect one end of the cable to an Ethernet port on the 4GE SSM as shown
b.
in Figure 15-1.
Figure 15-1 Connecting the Ethernet port
L N K
3
2
C is c o C is c o
S S M - 4 S S M - 4
G E G E
1
1 RJ-45 (Ethernet) port
Connect the other end of the cable to your network device.
c.
(Optional) If you want to use an SFP (fiber optic) port, install and cable the SFP
modules as shown in Figure
Insert and slide the SFP module into the SFP port until you hear a click. The
a.
click indicates that the SFP module is locked into the port.
Remove the optical port plugs from the installed SFP.
b.
Locate the LC connector (fiber optic cable) in the 4GE SSM accessory kit.
c.
Connect the LC connector to the SFP port.
d.
Chapter 15
1
0
S P D
15-2:
Configuring the 4GE SSM for Fiber
78-19186-01