Preparing The Appliance For Shipment; Deleting Devices From A Management Center - Cisco 7010 Installation Manual

Preparing the Appliance for Shipment

What to Do Next
•
Preparing the Appliance for Shipment
To prepare the appliance for shipment, you must safely power down and repackage the appliance:
•
•
•

Deleting Devices from a Management Center

Unless you deploy the Management Center and its managed device at the same target location, you must
delete the device from the Management Center. This prevents the device from looking for the UUID of
the original Management Center when you register the device to a different Management Center at the
target location.
To delete a device from the Management Center:
On the Management Center, Select
Step 1
Next to the device you want to delete, click the delete icon (
Step 2
When prompted, confirm that you want to delete the device. Communication between the device and the
Management Center is discontinued and the device is deleted from the Device Management page. If the
device has a system policy that causes it to receive time from the Management Center via NTP, the device
reverts to local time management.
After deleting the device from the Management Center, verify that the device is not remotely managed
by the Management Center.
To verify that a Firepower device is not managed by a Management Center:
On the Firepower device, you can use either the web interface or the CLI:
Step 1
•
•
Firepower 7000 and 8000 Series Installation Guide
E-4
On the Management Center, register the device using the registration information from your remote
management configuration. See the Firepower Management Center Installation Guide for more
information.
If your managed device will not be used in the same configuration at the target location, you must
delete the device from the Management Center, then power down and repackage the appliances. See
Deleting Devices from a Management Center, page
To safely power down the appliance, see
To ensure that your appliance is safely prepared for shipping, see
page E-5.
Admin
Access:
On the web interface of the Firepower device, go to
confirm that the Host list on the Remote Management screen is empty.
On the CLI of the Firepower device, run the command
displayed.
Appendix E
E-4.
Powering Down the Appliance, page
Devices > Device Management
System > Registration > Remote Management
show manager
Preconfiguring Firepower Managed Devices
E-5.
Shipping Considerations,
.
).
and confirm that no host is
and