Configuring The Adaptive Security Appliance; About The Factory Default Configuration - Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Manual

About the Factory Default Configuration

78-19186-01
Configuring the Adaptive Security
Appliance
This chapter describes the initial configuration of the adaptive security appliance.
You can perform the configuration steps using either the browser-based Cisco
Adaptive Security Device Manager (ASDM) or the command-line interface
(CLI). The procedures in this chapter describe how to configure the adaptive
security appliance using ASDM.
This chapter includes the following sections:
About the Factory Default Configuration, page 7-1
•
Using the CLI for Configuration, page 7-2
•
Using the Adaptive Security Device Manager for Configuration, page 7-3
•
Running the ASDM Startup Wizard, page 7-8
•
What to Do Next, page 7-9
•
Cisco adaptive security appliances are shipped with a factory-default configuration
that enables quick startup. The ASA 5500 series comes preconfigured with the
following:
Two VLANs: VLAN 1 and VLAN2
•
VLAN 1 has the following properties:
•
Named "inside"
–
C H A P T E R
Cisco ASA 5500 Series Getting Started Guide
7
7-1