About the Factory Default Configuration
78-18003-02
Configuring the Adaptive Security
Appliance
This chapter describes the initial configuration of the adaptive security appliance.
You can perform the configuration steps using either the browser-based Cisco
Adaptive Security Device Manager (ASDM) or the command-line interface
(CLI). The procedures in this chapter describe how to configure the adaptive
security appliance using ASDM.
This chapter includes the following sections:
•
About the Factory Default Configuration, page 5-1
Using the CLI for Configuration, page 5-2
•
Using the Adaptive Security Device Manager for Configuration, page 5-3
•
Running the ASDM Startup Wizard, page 5-9
•
What to Do Next, page 5-10
•
Cisco adaptive security appliances are shipped with a factory-default configuration
that enables quick startup. The ASA 5505 comes preconfigured with the
following:
Two VLANs: VLAN 1 and VLAN2
•
•
VLAN 1 has the following properties:
Named "inside"
–
C H A P T E R
ASA 5505 Getting Started Guide
5
5-1