Table of Contents
Advertisement
3.9.8 Time Zone
In this dialog, change your region and time zone by selecting them from the lists. Choose
between Local Time and UTC (GMT) under Hardware Clock Set To. The selection
depends on how the BIOS hardware clock is set on your machine. If it is set to GMT,
which corresponds to UTC, your system can rely on SUSE Linux Enterprise to switch
from standard time to daylight saving time and back automatically. Click Change to
set the current date and time. When finished, click Accept to return to the installation
settings dialog.
3.9.9 Performing the Installation
After making all installation settings, click Accept in the suggestion window to begin
the installation. Confirm with Install in the dialog that opens. The installation usually
takes between 15 and 30 minutes, depending on the system performance and the software
selected. As soon as all packages are installed, YaST boots into the new Linux system,
after which you can configure the hardware and set up system services.
3.9.10 IBM System z: IPLing the Installed
System
On the IBM System z platforms, another IPL must be performed after installing the
selected software packages. However, the procedure varies according to the type of
installation:
LPAR Installation
In the IBM System z HMC, select LOAD, select Clear, then enter the loading ad-
dress (the device address of the root device). If using a ZFCP disk as boot device,
choose LOAD from SCSI and specify both ZFCP WWPN and LUN of the boot
device. Now start the loading process.
z/VM Installation
Shut down the installed system with the halt command. Log in at the VM guest
under the account name LINUX1 and proceed to IPL the installed system. If using
a ZFCP disk as the boot device, specify both the ZFCP WWPN and LUN of the
boot device prior to initiating the IPL. Note that the parameter length is limited to
eight characters. Longer numbers must be separated by spaces:
Installation with YaST
55
Advertisement
Table of Contents
Troubleshooting
