Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 102

Preparing for VNC Installation
All you need to do on the installation target to prepare for a VNC installation is to
provide the appropriate boot options at the initial boot for installation (see
"Using Custom Boot Options"
environment and waits for a VNC client to connect to the installation program.
The installation program announces the IP address and display number needed to connect
for installation. If you have physical access to the target system, this information is
provided right after the system booted for installation. Enter this data when your VNC
client software prompts for it and provide your VNC password.
Because the installation target announces itself via OpenSLP, you can retrieve the address
information of the installation target via an SLP browser without the need for any
physical contact to the installation itself provided your network setup and all machines
support OpenSLP:
1 Start the KDE file and Web browser Konqueror.
2 Enter service://yast.installation.suse in the location bar. The
Connecting to the Installation Program
Basically, there are two ways to connect to a VNC server (the installation target in this
case). You can either start an independent VNC viewer application on any operating
system or connect using a Java-enabled Web browser.
Using VNC, you can control the installation of a Linux system from any other operating
system, including other Linux flavors, Windows, or Mac OS.
On a Linux machine, make sure that the package tightvnc is installed. On a Windows
machine, install the Windows port of this application, which can be obtained at the
TightVNC home page (http://www.tightvnc.com/download.html).
To connect to the installation program running on the target machine, proceed as
follows:
102 Installation and Administration
target system then appears as an icon in the Konqueror screen. Clicking this icon
launches the KDE VNC viewer in which to perform the installation. Alternatively,
run your VNC viewer software with the IP address provided and add :1 at the
end of the IP address for the display the installation is running on.
(page 99)). The target system boots into a text-based
Section 4.4.3,