Setting Up Your Data Synchronizer System; Performing Pre-Installation Tasks - Novell DATA SYNCHRONIZER - INSTALLATION GUIDE 07-2010 Installation Manual

Reconfigure the connection to your LDAP server
Reconfigure the Sync Engine
To protect your Synchronizer system operation and configuration, you must choose one LDAP
administrator user to access Synchronizer Web Admin. This LDAP user becomes the initial
Synchronizer administrator. Make sure that you know this administrator user's password.
SINGLE-SERVER DATA SYNCHRONIZER INSTALLATION SUMMARY SHEET
Under Synchronizer Web Admin, specify the LDAP administrator username and password that you want
to grant access to Synchronizer Web Admin.
You can add more users as Synchronizer administrators after installation, as described in
Up Multiple Synchronizer Administrator
Novell Data Synchronizer Administration

2.2 Setting Up Your Data Synchronizer System

You should already have reviewed
and filled out the Data Synchronizer Installation Summary
NOTE: If you are setting up a multi-server Synchronizer system, you should have a Summary Sheet
for each Synchronizer server. Each Synchronizer server is independent of other Synchronizer
servers, so you can set them up in whatever order is convenient given the overall configuration of
your Synchronizer system.
The following sections step you through the process of installing and configuring a Synchronizer
server.
Section 2.2.1, "Performing Pre-Installation Tasks," on page 21
Section 2.2.2, "Running the Data Synchronizer Installation Program," on page 22
Section 2.2.3, "Checking the Status of the Data Synchronizer Services," on page 24
Section 2.2.4, "Checking the Status of the GroupWise Connector," on page 24
Section 2.2.5, "Testing Your Data Synchronizer System," on page 25

2.2.1 Performing Pre-Installation Tasks

1 Make sure that the Linux server on which you plan to install Data Synchronizer meets the
system requirements listed in
page 12.
2 Make sure that the Synchronizer server has an assigned static IP address.
3 Make sure that any firewalls between the Synchronizer server and other applications have been
configured to allow communication on the following ports:
Port Number Description
636/389 LDAP server secure or non-secure port
4500 GroupWise Connector listening port for event notifications
Users" in "Managing Your Synchronizer
Guide.
Chapter 2.1, "Planning a Data Synchronizer System," on page 15
Sheet.
Section 1.2, "Data Synchronizer System Requirements," on
"Setting
System" in the
Data Synchronizer Installation 21