Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 952

52.7.2 Configuring Disks
In this state, no disks are configured. You need to configure them before you can pro-
ceed.
Procedure 52.3 Configuring DASDs
1 Configure DASDs with the following command:
2 Now the DASD is online (check with cat /proc/partitions) and can
Procedure 52.4 Configuring a zFCP Disk
1 To configure a zFCP disk, it is necessary to first configure the zFCP adapter. Do
2 After the adapter is activated, a disk can be configured. Do this with the following
3 Now the zFCP disk is online (check with cat /proc/partitions) and can
952 Installation and Administration
dasd_configure 0.0.0150 1 0
0.0.0150 is the channel to which the DASD is connected. The 1 means activate
the disk (a 0 at this place would deactivate the disk). The 0 stands for "no DIAG
mode" for the disk (a 1 here would enable DAIG access to the disk).
used for subsequent commands.
this with the following command:
zfcp_host_configure 0.0.4000 1
0.0.4000 is the channel to which the adapter is attached and 1 stands for acti-
vate (a 0 here would deactivate the adapter).
command:
zfcp_disk_configure 0.0.4000 1234567887654321 8765432100000000
0.0.4000 is the previously-used channel ID, 1234567887654321 is the
WWPN (World wide Port Number), and 8765432100000000 is the LUN
(logical unit number). The 1 stands for activating the disk (a 0 here would deac-
tivate the disk).
used for subsequent commands.
1