Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 04-08-2006 Installation Manual page 54

Select the keyboard layout from the list. By default, the layout corresponds to the se-
lected language. After changing the layout, test the characters that are special to the
selected language layout to make sure that the selection is correct. To set special options
regarding keyboard behavior, click Expert Settings. Find more information about that
in Section 7.4.8, "Keyboard Layout"
to the installation settings dialog.
3.9.6 Booting
TIP: IBM System z: Boot Loader Configuration
The module described below cannot be used to configure the boot loader (zipl)
on the IBM System z platforms.
During the installation, YaST proposes a boot configuration for your system. Normally,
you can leave these settings unchanged. However, if you need a custom setup, modify
the proposal for your system.
One possibility is to configure the boot mechanism to rely on a special boot floppy.
Although this has the disadvantage that it requires the floppy to be in the drive when
booting, it leaves an existing boot mechanism untouched. Normally this should not be
necessary, however, because YaST can configure the boot loader to boot other existing
operating systems as well. Another possibility with the configuration is to change the
location of the boot mechanism on the hard disk.
To change the boot configuration proposed by YaST, select Booting to open a dialog
in which to change many details of the boot mechanism. For information, read
tion 21.3, "Configuring the Boot Loader with YaST"
3.9.7 Default Runlevel
SUSE Linux Enterprise can boot to different runlevels. Normally there should be no
need to change anything here, but if necessary set the default runlevel with this dialog.
Refer to
runlevel configuration.
54 Installation and Administration
Section 7.5.13, "System Services (Runlevel)"
(page 155). When finished, click Accept to return
(page 411).
(page 167) for information about
Sec-