Table of Contents
Advertisement
24.4.1 Local Printers
If an unconfigured local printer is detected when you log in, YaST starts for configuring
it. This uses the same dialogs as the following description of configuration.
To configure the printer, select Hardware → Printer in the YaST control center. This
opens the main printer configuration window, where the detected devices are listed in
the upper part. The lower part lists any queues configured so far. If your printer was
not detected, configure it manually.
IMPORTANT
If the Printer entry is not available in the YaST control center, the
yast2-printer package probably is not installed. To solve this problem,
install the yast2-printer package and restart YaST.
Automatic Configuration
YaST is able to configure the printer automatically if the parallel or USB port can be
set up automatically and the connected printer can be detected. The printer database
must also contain the ID string of the printer that YaST retrieves during the automatic
hardware detection. If the hardware ID differs from the model designation, select the
model manually.
To make sure that everything works properly, each configuration should be checked
with the print test function of YaST. The test page also provides important information
about the configuration tested.
Manual Configuration
If the requirements for automatic configuration are not met or if you want a custom
setup, configure the printer manually. Depending on how successful the autodetection
is and how much information about the printer model is found in the database, YaST
may be able to determine the right settings automatically or at least make a reasonable
preselection.
The following parameters must be configured:
Printer Operation
455
Advertisement
Table of Contents
Troubleshooting
