Performing The Installation - Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 08-05-2008 Installation Manual

3.13 Performing the Installation

After making all installation settings, click Accept in the suggestion window to begin
the installation. Confirm with Install. Some software may require a license confirmation.
If your software selection includes such software, license confirmation dialogs are
displayed. Click Accept to install the software. When not agreeing to the license, click
I Disagree and the software will not be installed.
The installation usually takes between 15 and 30 minutes, depending on the system
performance and the software selected. During this procedure a slide show introduces
the features of SUSE Linux Enterprise. Choose Details to switch to the installation log.
As soon as all packages are installed, YaST boots into the new Linux system, after
which you can configure the hardware and set up system services.
3.13.1 IBM System z: IPLing the Installed
On the IBM System z platforms, another IPL must be performed after installing the
selected software packages. However, the procedure varies according to the type of
installation:
LPAR Installation
In the IBM System z HMC, select LOAD, select Clear, then enter the loading ad-
dress (the device address of the root device). If using a ZFCP disk as the boot device,
choose LOAD from SCSI and specify both ZFCP WWPN and LUN of the boot
device. Now start the loading process.
z/VM Installation
Shut down the installed system with the halt command. Log in to the VM guest
as LINUX1 and proceed to IPL the installed system. If using a ZFCP disk as the
boot device, specify both the ZFCP WWPN and LUN of the boot device before
initiating the IPL. The parameter length is limited to eight characters. Longer
numbers must be separated by spaces:
SET LOADDEV PORT 50050763 00C590A9 LUN 50010000 00000000
Finally, initiate the IPL:
IPL 151 CLEAR
34 Installation and Administration
System