Step 5: Set Target Project Information - Novell ADMINSTUDIO 9.5 User Manual

c. In the Command-line Argument(s) field, enter any command-line arguments to be used when this
setup is run.
d. Click OK to return to the Additional Setup Programs dialog box.
e. If necessary, click the Up and Down buttons to change the order in which the setups are run.
3. If you want to edit an existing setup program, perform the following steps:
a. On the Additional Setup Programs dialog box, select the program that you want to edit and click Edit. The
Setup Information dialog box opens.
b. Modify the Program File and Command-line Argument(s) fields.
c. Click OK to return to the Additional Setup Programs dialog box.
4. If you want to delete a listed setup program, perform the following steps:
a. Select the program that you want to delete and click Delete. A dialog box opens prompting you to
confirm the deletion.
b. Click OK to confirm the deletion and return to the Additional Setup Programs dialog box, where the
deleted program is no longer listed.
5. Click OK to return to the Collect Product Information panel.
6. Continue with

Step 5: Set Target Project Information

In this step, you identify the location where you want files created by Repackager to be stored. For the Installation
Monitoring repackaging method, it is recommended that this location not be located on your clean machine, but
rather on the same machine as the Repackager executable (most likely on your administrator machine).
AdminStudio 9.5 User Guide
Chapter 7: Repackaging Legacy Installations Using the Repackaging Wizard
Step 5: Set Target Project
ADS-0950-UG00
Repackaging Legacy Installations Using the Repackaging Wizard
Information.
461