Step 2: Configure The Ultrakey Touch For Dvr Use; Figure 3-4 Connecting The Controller For Dvr Control Using Rs485 - Honeywell UltraKey Touch HJC4000 Installation And User Manual

Connecting UltraKey Touch to a DVR
RS232-RS485
Converter
RJ45 Box

Step 2: Configure the UltraKey Touch for DVR Use

32
Figure 3-4 Connecting the Controller for DVR Control Using RS485
Serial Port (RS232)
Serial Port (RS485)
5
6
7
8
Network
Cable
Serial Port (RS485) Network Port
Master
UltraKey Touch
Note Set the DVR type in the Ultrakey Touch configuration to be the same as the
connected DVR type. If any other type has been selected, then use the
following procedure to select a different DVR type.
1. Install and connect the controller to a power source, if it is not already connected.
4
3
2
NETWORK
1
Network Network
Cable Cable
Slave1
Network Port