Step 3: Configure The Ultrakey Touch For Serial Port Settings - Honeywell UltraKey Touch HJC4000 Installation And User Manual

Step 3: Configure the UltraKey Touch for Serial Port Settings

Document 800-06554 Rev C
02/11
2. Press Login, and enter the password, 1234.
3. From the home screen, press Alt > Clr to enter the
System Configuration menu. Scroll the slider or rotate
the joystick until System Configuration: Standalone
Settings displays.
4. Press Ent or rotate the slider to select DVR type.
5. Press Ent to enter the DVR Selection menu. Press the
Slider_Up / Down to select the DVR to control.
6. Press Ent to enter the Basic Set menu. Press the
Slider_Up/Down until the Port Select submenu
displays.
7. Press Ent to enter the Port Select menu, then select
the RS485 protocol to controll the DVR, then press Ent
or Slider_Right to confirm.
8. Return to the home screen.
If the keyboard is in PTZ mode after changing to DVR
settings, then the home screen displays this message:
Select Yes or No to change the work mode of the
keyboard.
If the keyboard is in DVR mode after changing to DVR settings, then the home screen
does not display that message.
1. Press Alt > Clr to exit from the DVR configuration menu.
2. Before using the UltraKey Touch keyboard to control Fusion/HRXD/HRSD/HRDP
DVRs, it must be setup to meet the requirements. Set Com1 (RS485) according to
Table 3-5 on page 34.
UltraKey Touch Installation and User Guide
This indicates that the
keyboard is in PTZ mode.
CAM 001
ST User2
This indicates that the
keyboard is in DVR mode.
CAM 001 DVR 1
ST User2
System Configuration
Standalone Settings
Standalone Set:
DVR
DVR Selection DVR Selection
Fusion
DVR Selection
HRDP
DVR Selection
HRXD
Basic Set:
DVR/CAM
Basic Set:
PORT SELECT
Port Select
RS485
Change to DVR mode?
Yes
33