Step 2: Configure The Ultrakey Touch For Dvr Use; Figure 3-3 Connecting The Controller For Dvr Control; Note - Honeywell UltraKey Touch HJC4000 Installation And User Manual

Connecting UltraKey Touch to a DVR

Step 2: Configure the UltraKey Touch for DVR Use

28
Figure 3-3 Connecting the Controller for DVR Control

Note

Set the DVR type in the Ultrakey Touch configuration to be the same as the
connected DVR type. If any other type has been selected, then use the
following procedure to select a different DVR type.
1. Install and connect the controller to a power source, if it is not already connected.
2. Press Login, and then enter the password, 1234.
3. From the home screen, press Alt > Clr to enter the
System Configuration menu. Scroll the slider or rotate
the joystick until System Configuration: Standalone
Settings displays.
4. Press Ent and rotate the slider to select DVR.
RJ45 to
DB9F
for RS232
Network Network
cable cable
Serial Port (RS232) Network Port
Master
UltraKey Touch
This indicates that the
keyboard is in PTZ mode.
CAM 001
ST User2
NETWORK
Network
cable
Network Port
Slave1
This indicates that the
keyboard is in DVR mode.
CAM 001 DVR 1
ST User2
System Configuration
Standalone Settings
Standalone Set:
DVR