Touch Panel Configuration; How To Calibrate The Touch Panel; Service Contact Settings - Honeywell Touchpoint Plus Wireless Technical Handbook

MAN0984_Iss 2_09/19
3020M5001_2
To set or change Data Logging:
1) Log in as an Administrator or Service
2) Select Menu > Configuration > Log Interval & Threshold > mA Input and/or select Menu > Configuration >
Log Interval & Threshold > Wireless Input
3) Select a box and enter the details using the touchpad
4) Select Finish
5) Make other changes or Log Out

7.8 Touch Panel Configuration

To access the panel configuration:
1) Login as Service or higher access level
2) Select the Menu > Configuration > Display.
3) Select LCD Backlight Timeout and Brightness settings, or Start to calibrate the Touch Panel (see below)
4) Select Finish to return to the Configuration menu
Access Level: Service
Parameter Name
Backlight time out

7.8.1 How to Calibrate the Touch Panel

Calibrate the touch panel if the screen is not responding as expected.
To calibrate the screen:
1) Login as Service or higher access level.
2) Select the Menu > Configuration > Display.
3) Touch 'Start' next to Touch Panel Calibration.
4) Follow the instructions on screen.
5) Select Finish to return to the Configuration menu.

7.9 Service Contact Settings

To set the Service contact:
1) Login as Service or higher access level.
2) Select the Menu > Configuration > General > Service Contact.
3) Update the settings with your local service support contact details.
4) Select Finish to return to the Configuration menu.
Commissioning
Default Setting Value Range
30 seconds 30 seconds to 10
minutes or
Always On
This is the time that the backlight will remain on after
the touchscreen is idle.
If a new event occurs, the backlight will come on and
will remain on as long as the event remains
unacknowledged.
73
Touchpoint Plus Wireless
Technical Handbook
Comment