Installing And Configuring An Ethernet Connection; Step 1: Connect To The Ultrakey Touch Using The Ethernet Port; Table 3-6 Rj45 Ethernet Pin Assignments - Honeywell UltraKey Touch HJC4000 Installation And User Manual

Installing and Configuring an Ethernet Connection

Step 1: Connect to the UltraKey Touch Using the Ethernet Port

Document 800-06554 Rev C
02/11
Note DVR ethernet control is currently unavailable. It will be available in future
releases.
For a list of cable accessories see the
connections and pin assignments, see
on page 18. The UltraKey Touch Controller runs TCP/IP keyboard protocol.
Table 3-6 RJ45 Ethernet Pin Assignments
Port Pin
RJ45 Ethernet 1
2
3
6
1. Select the applicable adapter plug and insert it into the AC adapter. Push to click it
into place.
2. Plug the AC adapter into the controller power port and the adapter into a power
source.
3. Plug an RJ45 network cable from the network to the controller Ethernet port (see
Figure 3-5).
4. Connect a DVR to the network. Refer to the applicable
instructions.
Note To setup cascade linkage for UltraKey Touch, see
Cascade Linkage (Additional)
UltraKey Touch Installation and User Guide
Shipping Checklist on page 17, and for port
UltraKey Touch Port Connections and Descriptions
Signal
TX +
TX–
RX+
RX–
DVR Installation Guide
Keyboard Configuration for
on page 37.
for
35