Step 3: Configure The Ultrakey Touch Serial Port Settings; Table 3-2 Serial Port Com2 (Rs232) Configurations - Honeywell UltraKey Touch HJC4000 Installation And User Manual

Step 3: Configure the UltraKey Touch Serial Port Settings

Document 800-06554 Rev C
02/11
5. Press Ent to enter the DVR Selection menu. Press the
Slider_Up/Down to select the DVR to control.
6. Press Ent to enter the Basic Set menu. Press the
Slider_Up/Down until the PORT SELECT submenu
displays.
7. Press Ent to enter the Port Select menu, then select
the RS232 protocol to control a DVR. Press Ent or
Slider_Right to confirm.
8. Return to the home screen.
If the keyboard is in PTZ mode after changing to DVR
settings, then the home screen displays this message:
Select Yes or No to change the work mode of the
keyboard.
If the keyboard is in DVR mode after changing to DVR settings, then the home screen
does not display that message.
1. Press Alt > Clr to exit from the DVR configuration menu.
2. Before using the UltraKey Touch keyboard to control Fusion/HRXD/HRDP DVRs, it
must be setup to meet the requirements. Set Com2 (RS232) according to
Table 3-2 Serial Port Com2 (RS232) Configurations
Type
Baud Rate
Parity
DataBit
StopBit
3. Press Alt > Clr a second time to enter the System Configuration menu.
4. Rotate the slider to scroll through the options (standalone settings, serial port,
network, language, slider update, cascade linkage, hardware test, about, and restore
default).
5. When you are at the System Configuration: Serial
Port menu, press Ent to enter.
UltraKey Touch Installation and User Guide
RS232
9600
None
8
1
System Configuration
Serial Port
DVR Selection
Fusion
DVR Selection
HRDP
DVR Selection
HRXD
Basic Set:
DVR/CAM
Basic Set:
PORT SELECT
Port Select
RS232
Change to DVR mode?
Yes
Table 3-2.
29