Denon AVR-3801 Operating Instructions Manual page 44

• Selecting the PCM mode
Press the PCM button to switch to the PCM signal input.
• Selecting the DTS mode
Press the DTS button to switch to the DTS signal input.
3 Select the play mode.
Example: Stereo
SURROUND
MODE
(Main unit)
To select the surround mode while adjusting the surround
parameters, channel volume or tone control, press the
surround mode button then operate the selector.
4 Start playback on the selected component.
• For operating instructions, refer to the component's
manual.
5 Adjust the volume.
The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –60 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 23 or pages 49 and 50, if the volume for any
channel is set at +1 dB or greater, the volume cannot be adjusted
up to 18 dB. (In this case the maximum volume adjustment range
is "18 dB — (Maximum value of channel level)".)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to "DTS".
PCM
(Main unit)
DTS
(Main unit)
SELECT
STEREO
(Remote control unit)
SURROUND
MODE
(Main unit)
VOLUME
MASTER VOLUME
+
-
(Main unit) (Remote control unit)
Input mode display
• In the AUTO mode
INPUT
AUTO PCM DTS
• In the DIGITAL PCM mode
INPUT
AUTO PCM DTS
• In the DIGITAL DTS mode
INPUT
AUTO PCM DTS
• In the ANALOG mode
INPUT
AUTO PCM DTS
Input signal display
• DOLBY DIGITAL
SIGNAL
LOCK DIGITAL
• DTS
SIGNAL
LOCK DIGITAL
• PCM
SIGNAL
LOCK DIGITAL
The LOCK LED lights when digital signals are being input properly.
If the LED does not light, check whether the digital input
component setup (page 25) and connections are correct and
whether the component's power is turned on.
NOTE:
• The digital input indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
One of these lights, depending on the
input signal.
DIGITAL ANALOG
DIGITAL
DIGITAL
ANALOG
43