Denon AVR-3801 Operating Instructions Manual page 20

2 Switch to the speaker configuration screen.
ENTER
SHIFT
3 Set whether or not speakers are
TUNING
connected and, if so, their size
parameters.
BAND MODE
• To select the speaker
TUNING
• To select the parameter
TUNING
BAND MODE
TUNING
4 Enter the setting.
ENTER
a) If no surround speakers are used (if "None" is set for both A and B):
SHIFT
b) If both surround speakers A and B are used (if either "Large" or "Small" is set for both A and B):
c) If "None" is set for surround speakers A:
NOTE:
• Select "Large" or "Small" not according to the actual size of the speaker but according to the speaker's capacity for playing low frequency
(approximately 80 Hz and below) signals. If you do not know, try comparing the sound at both settings (setting the volume to a level low
enough so as not to damage the speakers) to determine the proper setting.
• Parameters
Large...... Select this when using speakers that can fully reproduce low sounds of below 80 Hz.
Small...... Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient volume.
When this setting is selected, low frequencies of below 80 Hz are assigned to the subwoofer.
None...... Select this when no speakers are installed.
Yes/No.... Select "Yes" when a subwoofer is installed, "No" when a subwoofer is not installed.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when "Small" is set for the front, center
and surround speakers.
For the majority of speaker system configurations, using the SMALL setting for all five main speakers and Subwooofer On with a connected
subwoofer will yield the best results.
Selecting the surround speakers for the different surround modes
• At this screen preset the surround speakers to be used in the different surround modes.
1 When either "Large" or "Small" has been set for both speakers A and B
TUNING
on the System Setup Menu (when using both A and B surround speakers),
the surround speaker setting screen appears.
BAND MODE
Select the surround speakers to be used in the different surround modes.
TUNING • To select the surround mode
• To select the surround speaker
TUNING A:
B:
BAND MODE
A+B: When using both surround speakers A and B
TUNING
The Subwoofer Mode screen appears.
The surround speaker setting screen appears.
"None" is automatically set for surround speakers B and surround back.
When using surround speakers A
When using surround speakers B
Center Sp.
Front Sp.
Subwoofer
Surround Sp. A
Surround back Sp.
Surround Sp. B
19