Denon AVR-3801 Operating Instructions Manual page 26

When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect
ALL surround modes. Consider this mode a Master Channel Level adjustment mode.
After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and
adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode,
your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each
surround mode on page 49.
You can adjust the channel levels for each of the following surround modes: DIRECT, STEREO, 5/7 CH STEREO, DOLBY/DTS SURROUND,
WIDE SCREEN, ROCK ARENA, JAZZ CLUB, VIDEO GAME, MONO MOVIE, and MATRIX.
When using either surround speakers A or B, or when using surround speakers A and B at the same time, be sure to adjust the balance of
playback levels between each channel for the various selections of "A or B" and "A and B".
Setting the Digital In Assignment
• This setting assigns the digital input jacks of the AVR-3801 for the different input sources.
1 At the System Setup Menu select "Digital In Assignment".
TUNING
BAND MODE
TUNING
2 Switch to the Digital Inputs screen.
ENTER
SHIFT
3
TUNING
BAND MODE
TUNING
4 Enter the setting.
ENTER
The System Setup Menu reappears.
SHIFT
NOTES:
• The OPTICAL 3 jacks on the AVR-3801's rear panel are equipped with an optical digital output jack for recording digital signals on a CD
recorder, MD recorder or other digital recorder. Use this for digital recording between a digital audio source (stereo - 2 channel) and a digital
audio recorder.
• Do not connect the output of the component connected to the OPTICAL 3 OUT jack on the AVR-3801's rear panel to any jack other than the
OPTICAL 3 IN jack.
• "PHONO" and "TUNER" cannot be selected on the Digital In Assignment screen.
Select the digital input jack to be assigned to the input source.
TUNING • To select the input source
• To select the digital input jack
BAND MODE
Select "OFF" for input sources for which no digital input jacks are used.
If "Yes" is selected for "Default", the settings are automatically reset to the default values.
TUNING
25