Setting The Channel Level - Denon AVR-1907 Operating Instructions Manual

Advanced Setup – Part 2
1
2
• The distance changes in units of 0.5 foot each time the button is
pressed. Select the value closest to the measured distance.
• Please note that the difference of distance for every speaker
should be 20 ft or less.

Setting the Channel Level

Set the volume of the various speakers so that the sound output from
..... L1
..... L2
the speakers and the subwoofer seems to have the same volume
..... L3
level.
..... L4
..... L5
..... L6
..... L7
1 D D H H
Press to select "Channel Level", then press
..... L8
2
F F G G
Press to set.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output switched
manually.
3 D D H H
Press to select "Test Tone Start", then press
select "Yes".
4
When "Auto" mode is selected:
F F G G
Press to adjust the volume.
-1
• Test tones are output automatically, in the order shown below.
FL C
SW SL
The volume can be adjusted within the range –12 dB to +12 dB.
4
When "Manual" mode is selected:
D D H H
Press to select the speaker, then press
-2
adjust the volume.
5
ENTER
Press .
56
ENGLISH
1
ENTER
.
3
• To cancel the setting, press H H and select "Level Clear", then press
F F and select "Yes".
F F
to
FR SR
(2 speakers)
• To adjust the channel level separately for the different play modes
SBL SBR
after setting the channel level, perform the operation on page 32.
(1 speaker)
SB
F F G G
to
ENGLISH
Advanced Setup – Part 2
2
4
-1