Option Setup; Setting The Power Amplifier Assignment; Setting The Volume Control - Denon AVR-1907 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 1

Option Setup

Setting the Power Amplifier Assignment

To suit your preference, a surround back channel's power amplifier
can be assigned to the front channel ("Front A" or "Front B") for bi-
amp playback, ZONE2.
Power Amplifier SPEAKER OUT
Assignment MAIN ZONE
Surround Back 7.1ch system
ZONE2 5.1ch system 2ch system
Bi-Amp 5.1ch system
1 D D H H
Press to select "Option Setup", then press
2 D D H H
Press to select "Power Amp Assign", then press
ENTER
.
3 F F G G
Press to set.
S. Back:
The surround back speakers are used in MAIN ZONE.
ZONE2:
This mode assigns the surround back amplifier channels to provide
ZONE2 speaker-level outputs from the surround back speaker
terminals.
Front A, Front B:
This provides a bi-amp mode for the two main front speakers,
replicating the front A or front B amplifier channel's outputs.
4
ENTER
Press .
1
PRE-OUT
ZONE2 S.BACK/ZONE2
– Surround back
ZONE2
– –
ENTER
.
Dynamic sound with a range wider than that of full range
systems can be played by connecting bi-amp compatible
speakers to the AVR-1907. Be sure to consult the owner's
manual of your bi-amp-capable speakers for further
information before proceeding.
NOTE:
• When making bi-amp connections, be sure to remove the
short-circuiting bar included with the speaker.
2
3
Front Bi-Amp connections
AVR-1907
Speaker [R] Speaker [L]
53
ENGLISH
Advanced Setup – Part 1

Setting the Volume Control

This sets the volume level of output.
1
D D H H
Press to select "Volume Control", then press
ENTER
.
2
D D H H
Press to select the item, then press
Volume Limit:
Set the volume's upper limit.
• OFF:
If you do not want to set a volume limit, select "OFF".
In this case, the volume can be set to the AVR-1907's maximum
volume (output) level of +18 dB, which is extremely loud.
• –20 dB, –10 dB, 0 dB:
The volume cannot be increased above the selected levels.
Power On Level:
Set the volume level when the power is turned on.
You can adjust the MAIN ZONE volume level within the range of
–80 to +18 dB.
• LAST:
The volume set when the AVR-1907 was last used is stored in the
memory and set when the power is turned on.
• – – – (Mute):
The volume is always muted when the power is turned on.
Mute Level:
Set the level of volume attenuation in the mute mode.
• FULL:
The volume is fully muted.
• –20 dB, –40 dB:
The volume is lowered 20 dB or 40 dB from the current level.
3
ENTER
Press .
1
2
F F G G
to set.