Recording (Audio And/Or Video); About The Memory Functions; Initialization Of The Microprocessor (Reset) - Denon AVR-1907 Operating Instructions Manual

Advanced Operation

Recording (audio and/or video)

< ZONE2/REC SELECT >
1
Press until "RECOUT" appears
on the display.
ZONE2 RECOUT
2 < FUNCTION >
Use to select the source to be recorded
(audio and/or video).
• The " " indicator and the indicator for the selected
source light.
3
Record (the audio or video signals).
For operations, see the operating instructions of the device from
which you are recording (audio or video signals).
• To cancel, press < ZONE2/REC SELECT > and set the function to "ZONE2".
NOTE:
• When the REC OUT mode is selected, [ZONE2] and [FUNCTION]
(ZONE2) cannot be operated.
• Digital signals are not output from the analog REC OUT terminal.

About the memory functions

¢ Last function memory
The various settings set when the AVR-1907's power is switched to
standby are stored in the memory. When the power is turned back on,
the settings made when the power was switched to standby are
recalled.
¢ Backup memory
The various settings are stored in the memory for about 1 week, even
when the power is turned off or the power cord is unplugged.

Initialization of the microprocessor (Reset)

Use the procedure described below to reset the microprocessor if the
display is abnormal or if the buttons on the main unit or the remote
control unit do not operate.
1 < POWER >
Switch off the unit using
< SPEAKER >
2
Hold the following (
< POWER >
.
3 Check that the entire display is blinking with an interval
of about 1 second, and release your fingers from the 2
buttons.
• The microprocessor will be initialized.
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the settings are reset to the
default values.
42
ENGLISH
.
A B
and ) and press
ENGLISH
Advanced Operation