Setting The Subwoofer Setup; Setting The Distance - Denon AVR-1907 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 2
A subwoofer with sufficient low frequency playback capability can
better handle deep bass than most main and surround speakers,
and the system's overall performance will be greatly enhanced
when "Small" is set for the main (front) and surround speakers.
When "Front" is set to "Small", "Subwoofer" is automatically set
to "Yes", and when "Subwoofer" is set to "No", "Front" is
automatically set to "Large".
4
ENTER
Press .
1
2
3
Center speaker
Front speaker
Subwoofer
Surround speaker
Surround back speaker
• Select "Large" or "Small" not according to the actual size of the speaker
but according to the speaker's capacity for playing low frequency
(bass sound below the frequency set for the Crossover Frequency)
signals. If you do not know, try comparing the sound at both settings
(setting the volume to a level low enough so as not to damage the
speakers) to determine the proper setting.

Setting the Subwoofer Setup

Select the method of playback of the subwoofer for playing the low
bass signals.
1
D D H H
Press to select "Subwoofer Setup", then press
ENTER
.
2
F F G G
Press to set.
LFE (Normal):
For any channel(s) that are set to "Large", low frequencies in that
channel's corresponding source are directed to that loudspeaker
only. The low frequencies played from the subwoofer are only the
LFE signals and the low frequencies of channels set to "Small".
LFE+Main:
Low frequencies from speaker channels that have been set to
"Large" are reproduced from those speakers as well as from the
subwoofer(s).
3
ENTER
Press .
1
2
• The subwoofer mode setting is only valid when and "Yes" is set for
the subwoofer in the "Setting the Speaker Configuration".
• Select the "LFE+Main" mode if you want low frequency signals to
always be played from the subwoofer channel.
• Select the mode achieving a voluminous bass sound when playing
music or movie sources.
55
ENGLISH
Advanced Setup – Part 2

Setting the Distance

This parameter is for optimizing the timing with which the audio
signals are produced from the speakers and subwoofer according to
the listening position.
Preparations:
Measure the distances between the listening position and the
speakers (L1 to L8 on the diagram at the below).
FL C
SW
L3
L1 L2
L8
L4 L5
SL
L6 L7
SBL SBR
1 D D H H
Press to select "Distance", then press
2
D D H H
Press to select the speaker, then press
3
ENTER
Press .
FR
Listening position
SR
ENTER
.
F F G G
to set.