Setting The Crossover Frequency - Denon AVR-1907 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 2
¢ Adjusting the test tone using the remote control
unit
Adjustment of the test tones using the remote control unit is only
possible in the "Auto" mode and only valid in the STANDARD (Dolby/
DTS Surround) mode. The adjusted levels are automatically stored for
the different surround modes.
1
[TEST TONE]
Press .
• Test tones are output from the different speakers.
2
F F G G
Press to adjust the volume.
3
[TEST TONE]
Press .

Setting the Crossover Frequency

Set the frequency (Hz) below which the bass sound of the various
speakers is to be output from the subwoofer.
For speakers that are set to "Small", frequencies under the crossover
frequency are cut before the signal is output, and the low frequency
component that was cut is output from the subwoofer or the
speakers that are set to "Large".
1
D D H H
Press to select "Crossover Frequency", then
ENTER
press .
2
F F G G
Press to set.
40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:
Set as desired according to your speakers' bass playback ability.
3
ENTER
Press .
1
2
• The crossover frequency mode is valid only when subwoofer is set
to "ON", and when one or more speakers are set to "Small", as
described in section "Setting the Speaker Configuration" (
54, 55).
• If "LFE+Main" is set at "Subwoofer Setup", "SW:LFE+Main" (
page 55) is displayed at the top right of the screen.
• Set to "80 Hz" when using regular speakers. When using small
speakers, we recommend setting to a higher frequency.
57
ENGLISH
page
Advanced Setup – Part 2