HEIDENHAIN ITNC 530 - 6-2010 DIN-ISO PROGRAMMING User Manual page 600

Global Program Settings software option
Function for superimposing
coordinate transformations in
the Program Run modes
Adaptive Feed Control software option (AFC)
Function for adaptive feed-
rate control for optimizing the
machining conditions during
series production
KinematicsOpt software option
Touch-probe cycles for
automatic testing and
optimization of the machine
kinematics
3D-ToolComp software option
3-D tool radius compensation
depending on the tool's
contact angle
FCL 2 upgrade functions
Enabling of significant
improvements
600
Swapping axes
Superimposed datum shift
Superimposed mirroring
Axis locking
Handwheel superimposition
Superimposed basic rotation and datum-based rotation
Feed rate factor
Recording the actual spindle power by means of a teach-in cut
Defining the limits of automatic feed rate control
Fully automatic feed control during program run
Backup/restore active kinematics
Test active kinematics
Optimize active kinematics
Compensate the delta radius of the tool depending on the tool's contact angle at the
workpiece
Prerequisite: LN blocks
Compensation values can be defined in a separate table
Virtual tool axis
Touch probe cycle 441, Rapid Probing
Offline CAD point filter
3-D line graphics
Contour pocket: Assign a separate depth to each subcontour
smarT.NC: Coordinate transformation
smarT.NC: PLANE function
smarT.NC: Graphically supported block scan
Expanded USB functionality
Network attachment via DHCP and DNS
Tables and Overviews