Power-On Microprocessor Reset Procedures; Cloning - Yaesu FT-897 Operating Manual

P -
OWER ON
P - M
OWER ON ICROPROCESSOR
P
ROCEDURES
Some or all transceiver settings can be reset to their factory-
default states using one of the following power-on routines:
Ì [ V/M ] + POWER on: Resets all memories and follow-
ing menu settings to their factory-default values:
Menu #06 (AM STEP), 33 (DCS CODE), 52 (FM STEP),
56 (MEM TAG), 76 (RPT SHIFT), 82 (SSB STEP), and
83 (TONE FREQ).
Ì [ F ] + POWER on: Resets all menu settings (except the
following menu items) to their factory-default values.
Menu #06 (AM STEP), 33 (DCS CODE), 52 (FM STEP),
56 (MEM TAG), 76 (RPT SHIFT), 82 (SSB STEP), and
83 (TONE FREQ).
Ì [ HOME ] + POWER on: CPU master reset for all memo-
ries and menu settings.
FT-897 O M
PERATING ANUAL
M
ICROPROCESSOR
R
ESET
R P
ESET ROCEDURES
C
You can transfer all data stored in one transceiver to another
set by utilizing the handy "Cloning" feature. This requires a
user-constructed cloning cable which connects the CAT/
LINEAR jacks on the two transceivers, as shown below.
TX D
RX D
GND
To clone from one transceiver to another, use the following
procedure:
1. Insert the Clone Cable into the CAT/LINEAR jack of
each transceiver.
2. Turn both transceivers off, then press and hold in the
MODE ( ) and MODE ( ) but-
tons on each radio while turning
the power on again. The "CLONE
MODE" notation will appear on
the display.
3. On the "destination" radio, press
the [ A ] key.
4. Now, on the "source" radio, press
the [ C ] key. Data will now be
transferred to the "Destination"
radio from the "Source" radio.
5. If there is a problem during the
cloning process, "Error" will be
displayed.
Check your cable connections
and try again.
6. If cloning is successful, turn the
"destination" radio off. Now turn
the "source" radio off.
7. Remove the clone cable. Channel and operating data for
both radios are now identical. They both may be turned
on now for normal operation.
/ C
LONING
LONING
TX D
RX D
GND
[ Distination radio ]
[ Sourcu radio ]
Page 63