3Com MSR 50-40 ROUTER. Installation Manual page 68

'.' = clear field; '-' = go to previous field;
boot device
processor number
host name
file name
inet on ethernet (e) : 192.168.80.10
inet on backplane (b):
host inet (h)
gateway inet (g)
user (u)
ftp password (pw) (blank = use rsh): 123456
flags (f)
target name (tn)
startup script (s)
other (o)
Table 5-8 Ethernet parameters settings description
Parameter
boot device
processor number
file name
inet on ethernet (e)
inet on backplane (b)
host inet (h)
gateway inet (g)
user (u)
ftp password (pw) (blank = use rsh)
flags (f)
target name (tn)
startup script (s)
other (o)
: mottsec0
: 0
: host
: main.bin
: 192.168.80.200
:
: guest
: 0x80
:
:
:
Boot device name, not allowed to be modified.
Number of processors, no need to change.
Name of the file to be downloaded, which must be
consistent with the actual file name. Designate a
downloading path while designating a filename; or
designate a downloading path in FTP and TFTP settings.
Set it to be in the same network with TFTP/FTP server. It
has nothing to do with port IP address of the router.
Separate the mask from the IP address if a mask is
needed, for example: 192.168.80.10:24.
Backplane address, no need to set.
IP address of the FTP or TFTP server
Gateway IP address, no need to set.
Username. This setting is used in FTP downloading. No
need to set in TFTP downloading.
FTP downloading password. No need to set in TFTP
downloading.
Downloading flag. The flag is 0x0 with FTP downloading,
and 0x80 with TFTP downloading.
No need to set. If set, it means the target file name saved
in Flash memory. If not, the one used for the last upgrade
is used.
No need to set.
No need to set.
5-13
Ctrl+D = quit
Description