C Pc-Copy Condition Function - FUTABA 9ZAP - PART1 Manual

C PC—COPY Condition Function
This function may be used to copy individual
flight conditions. One use would be to copy the
default flight condition, with all its subtrims,
mixing, etc. to another flight condition, and chang-
ing only the necessary parts. This procedure can
save a lot of time and unnecessary effort.
This function may also be used to delete flight
conditions (other than default) from the CAMPac
memory module. The MSL (Model Select) func-
tion may be used to delete the model data.
Reading the Condition List
To display the condition list, press the LST (R)
key. This displays conditions 1—10. To view the next ten
conditions, press the NXT (P)
preceding ten conditions, press the
Conditions nos. 01-50 are stored in the transmitter, and
nos. 51-70 are stored in the optional CAMPac memory
module.
Flight Condition Copying
Follow the following instructions to copy one flight con-
dition to another:
1. Use the numeric keys on the display bottom to input
the Source condition number. The 1,15,30,45,60,
and 72 keys input the key's value directly. The ( + )
and ( - ) keys may be used to increase or decrease
the displayed value by one for each key press. When
you are satisfied with the source number, press the
SET (O) key.
2. Now use the numeric keys to enter the Destination
condition number. Once again, enter the condition
number with the numeric keys at the display bottom,
and press the SET (O) key.
3. If you are happy with both condition numbers, press
the YES (L) key to execute the copy. If not, press
the NO (M) key to stop copying.
4. To continue copying further sets of conditions, press
the CNT (L) key and repeat the instructions
beginning from step 1.
To end copying, press the END ( N ) key.
Destination Condition Number -
Numeric Keys Used to Choose Condition Numbers
key. To view the
PRE (O) key.
System Section, Page 32
The entire model data may be copied under the
following conditions:
1. If the destination type is different from the
source, the set data are copied.
2. If the destination type is the same as the source,
all the set data are copied except for the condi-
tion name.
3. If the source is not allocated to a model mem-
ory ("00"), all the set data, including the model
name, is copied.
Source Condition Number
Flight Condition Deletion
To delete conditions from the CAMPac memory module,
follow the following instructions:
1. Press the DEL (A) key to enter the deletion mode.
2. Press the + or - (F or G) keys to select the con-
dition to be deleted.
3. If the condition is correct, press the DEL (Q) key,
then confirm using the YES (L) key.
4. To continue deleting, press the CNT (L) key and
repeat the instructions beginning from step 1.
To end copying, press the END (N) key.
01~50: Transmitter
Condition No. (
51~72: Memory Module
System Section
-Show Condition List
-Confirm Condition
Number
Return to System
Menu