Rev-Servo Reversing Function - FUTABA 9ZAP - PART1 Manual

REV—SERVO REVERSING FUNCTION
This function is used to reverse the direction a
servo operates for a given command. This function
should be used AFTER any special menus are de-
fined to assure that all servos are moving the cor-
rect directions.
Reversing Procedure
After defining a new model, be sure to define all
special menus (such as Flaperons, Aileron-Speed Flap
mixing. Differential, etc.). Be sure that all servos are
plugged into the proper receiver channels. Now, deter-
mine whether you need to reverse any channels by mov-
ing each stick and observing the corresponding movement
in the model's controls.
In the Model Menu, press the reverse function key
(REV) to get the Reversing menu shown below.
Channel Selection Keys
Now you must choose which channels you want to
reverse. Use the Up-Arrow keys (E M) to select the
desired channels.
Once you have selected the desired channel, use the
NOR (Q) key and the REV (P) key to choose the
proper direction for the servo. Repeat for each servo
needing reversal.
When done, press the
the Model Menu.
Model Setting Section, Page 44
Model Setting Section
Direction Selection
Keys
NOR = Normal
REV = Reverse
Return to the Model Menu
END ( N ) key to return to