Mode selection
Press the Mode Selection A key. then press the NXT
L key to get to the mode setting menu. To choose the
EXP1 mode, press the EX1 I
EXP2 mode, press the EX2 J key.
Side A curve rate setting
Set the rate as described earlier. If you need to change
the polarity of the exponential response, use the +/-
F key
Side L rate setting
Set the rate as described earlier. Note this setting is
not available for EXP2 mixing.
key. If you want the
Common Conditions Section, Page 63
Linear Mode Mixing
To set the linear mode, do the following: press the A
key, then press the LIN H key. This automatically
sets the side A and side B rate curves to —16%, to ap-
proximate linear response.
Ending
Press the
END N key to exit to the Condition
menu.
Common Condition Section