Neutral Brake "Ntbrk - FUTABA 4PL-2.4GHZ Instruction Manual

Neutral brake "NTBRK"

This is a function select switch function. The neutral brake function ON/OFF switch
must be set. (P62)
The neutral brake, which applies the brakes at the neutral position of the throttle trig-
ger, can be set. However, when using the MC950CR, MC851C, MC602C, MC402CR,
or other Futaba MC (Motor Controller), confirm that the MC is in the neutral position
and the set is in the operation mode before setting the neutral brake function switch to
ON, the same as the idle up function (P79). In addition, when the idle up function (P79)
or throttle off function (P81) is set, this function has a higher priority than the neutral
brake function.
Reference
The ESC neutral brake function and T4PL neutral brake function can be used simulta-
neously. However, when setting is difficult to understand, we recommend that only one
neutral brake function be used.
Dial / Trim Setting
When the neutral brake function is
matically assigned to the throttle trim (DT1/2/3/4 or DL1).
Operation display
An LED blinks while the neutral brake function is active.
< NO SW >
I f f u n c t i o n 's O N / O F F
switch is not selected,
<NO SW> is displayed.
The function select switch
screen (P62) can be dis-
played from this screen.
Neutral Brake function adjustment
(Preparation)
- Use the function select switch to select the switch. (page 62)
1
(Neutral brake rate)
Select the setting item "NTBRK" by (UP) or (DN) button. Use
the (+) and (-) buttons to set the neutral brake rate.
2
When ending, return to the ADVANCE menu screen by
pressing the (CT) button.
Effect of set value of other functions on neutral brake
Throttle side EPA function, or ATL function setting, also affects neutral brake side
operation.
80
ON , the neutral brake rate adjustment is auto-
" "
If the power switch is
turned on while the neu-
tral brake switch is on,
an audible alarm will be
heard. Immediately set
the neutral brake switch
to OFF.
Throttle Mode "THR MODE"
Warning display
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Brake rate (NTBRK)
0 ~ B100
Initial value: 0