FUTABA 4PL-2.4GHZ Instruction Manual page 77

The programmed DT button is used to select the drive type
as shown in the figure below.
2
(Rear side travel adjustment)
Select the setting item "RATE" by (UP) or (DN) button. Use
when applying a rotation difference to the front and rear
wheels by adjusting the rear (CH4) motor controller travel
with the (+) or (-) button.
3
(Mix mode setting)
Select the setting item "MXMD" by (UP) or (DN) button. Set
the mix mode with the (+) or (-) button.
"OFF" : CH2 EXP function and other settings are not mixed.
"ON" : CH2 EXP function and other settings are mixed.
4
(Trim mode setting)
Select the setting item "TRIM" by (UP) or (DN) button. Set
the trim mode with the (+) or (-) button.
"OFF" : Front side (CH2) trim data is not included.
"ON" : Front side (CH2) trim data is included.
5
When ending, return to the ADVANCE menu screen by
pressing the (CT) button.
Dial / Trim Setting
The function select dial function can control the 4th channel's ESC (Rear side) rate
(RATE) with digital dial or digital trim, using the function select dial function. (See
page 60)
Note:
As this function drives 2 separate motor controllers simultaneously, a mutual load is
applied. Use this function carefully so that the motor controllers are not damaged. Fu-
taba will not be responsible for motor controller, motor, and other vehicle trouble due
to use of this function.
Dual ESC mixing "DUAL ESC"
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Rear rate (RATE)
0 ~ 120
Initial value:100
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Trim mode (TRIM)
OFF, ON
Initial value: OFF
77