Backing Up The Controller Configuration - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Backing Up the Controller Configuration

Figure 6-5
If you want to backup your current controller configuration, go to the
Step 3
Configuration" section on page 6-4
If you want to continue with the reset of the controller, click Yes.
Step 4
When the reset process is complete, CCA returns to the main CCA screen displaying the Topology View.
If you click the Refresh icon, CCA refreshes the topology view and the previously configured controller
is shown not connected to the switch. CCA also detects the unconfigured controller with a default IP
address of 192.168.1.1 connected to the controller. To configure the controller, go to the
Controller" section on page

Backing Up the Controller Configuration

You can backup the controller configuration during the process of resetting the controller to defaults or
from the Maintenance options. This section describes both methods of backing up the controller
configuration.
On CCA Release 1.5, the CCA restore function only supports backup files created using CCA
Note
Release 1.5. You cannot use backup files created with CCA Release 1.1. CCA Release 1.1 supports
binary configuration files, but CCA Release 1.5 and higher supports XML configuration files.
To back up a controller configuration, follow these steps:
Step 1 Click Launch Configuration Archive from the Restart/Reset pop-up message window or click
Maintenance > Configuration Archive.
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
6-4
Chapter 6
Restart/Reset Message
for additional instructions.
2-2.
Figure 6-6
Restarting, Resetting, Backing Up, and Restoring the Controller
"Backing Up the Controller
appears.
"Adding a New
OL-15283-01