Cisco 521G - Unified IP Phone VoIP Configuration Manual page 52

Creating a New WLAN
Figure 4-7
Step 19 If you choose WPA security, perform these steps:
Click the Encryption drop-down arrow and choose aes or tkip.
a.
Click the Authentication drop-down arrow and choose one of these authentication options:
b.
–
–
–
If you choose WPA-PSK, WPA2, or WPA2-PSK security, perform these steps:
Step 20
Click the Encryption drop-down arrow and choose AES or TKIP.
a.
Note
Enter the WPA pre-shared key (8 to 63 characters long).
b.
If you selected a voice WLAN type, choose one of these voice CAC types:
Step 21
• Wireless MultiMedia Policy—(Default) requires client devices to use WMM.
7920 CAC (AP and Client)—Supports Cisco 7920 IP telephones on your network.
•
Step 22 Click OK and the specified WLAN information is visible in the WLAN Names list (see
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
4-6
Passphrase and Auto-Generated Hex Key
802.1x (default)
Fast roaming (CCKM)
802.1x, fast roaming (CCKM)
The authentication is WPA-PSK, WPA2-PSK, or WPA2-PSK corresponding to the security type.
Chapter 4 Creating and Modifying WLANs and VLANs
Figure 4-8).
OL-15283-01